I set up ring groups (hunting) that worked just 24 hours ago. I returned to continue with my configuration today, and the configuration was on Ring All . So put it back to hunt, but now it never goes through the hunbt sequence, it just goes to the final destination (no annser destination)
The ringall seems to be the only mode that works. I even deleted and recreated the hunt groups and routing.
I believe theta hunting may still be buggy, on the part where the call goes to the final or no answer destination. My configuration is as follows:
Inbounds rout to Hunt group 1 , Hunt group 1 rings 201 and 301 simultaneously. If no answer I am forwarding to a PSTN number.
The PSTN forward I have tried setting up on 2 different trunks with a classic extension as well as a third SIP extension that dials DNIS@myserver.com I have confirmed that the address DNIS@myserver.com is working I can route other traffic to it and it routes to the PSTN number. I was also able to connect that SIP extension to FWD echo test one time 613@fwd.pulver.com , however on subsequent calls after it rang through the hunt group it rang with no answer.
This ring with no answer is the most typical result I get , however at times, calls have rung trough and the recipient hearts onlyt a motorboatring noise.
The trunks both work fine when dialing from an extension.
I have had more success with reaching the final destination if the ring time to the ring group is less than 25 seconds
We have a ring group #1 for extension #201 and #202.
#201 must ring first, then #201 and #202 (memory hunt).
Destination if no answer: Voicemail #209.
When using the hunt or memory hunt policy, the caller always get an error after ~20sec "the call cannot be completed as dialed, please try your call again later". When using the ringall policy, the call is properly forwarded to the voicemail IF the ring time is no more than 20 seconds. Any higher value gets the error message.
How is this value taken into account in the context of a hunt? Is it the ring time for each extension of the list of the complete ring group?
In General Settings, we've set to transfer calls to voicemail after 25 seconds ringtime (I've also tried to increase/decrease this value without success).
The extensions 201 and 202 themselves have voicemail disabled, so this should not conflict.
In my opinion, there should still be a bug with the hunting feature.
Please help, I've been searching over this issue for more than one hour
This post has been edited 1 time(s), it was last edited by opf on 13.07.2011 at 16:22.
Hi, i have a issue with my ring group.
I just bought a Grandstream HT503 gateway to receive PSTN calls on my pbx extensions.
But somethime i get Bulk Calls.
On my phone display i get number 111 and sometimes 100 and sometimes 1001.
What can i do to fix this?