Inbound Routing problem,no real time changes

Hi,

I settup in "Inbound Routing" one of my SIP provider to ring extension (1002)
If I call my trunk all calls are routed on the "Digital Receptionist"!
I am not sure but I think changes made in the web interface of PBXES are not apply in real time?
I have similar problems on other setting...
Any idea?

Regard

If this posting and the one below concern the same subject, go into the Personal Data section, click "Submit & Start" and see if the issue gets resolved.

Zitat:

Originally posted by echelon92 Hi, I don't know if it is a similar problem but it seems that If I make changes in Trunk or anywhere else in my PBXES interface changes are not applied immediately... Regards Richard

Hi,

Thank you for your reply but I already done a submit & start but I have always the same problem.

In Outbound Routing,Trunk sequence, I changed SIP operator order (Wengo was in first position) and select Free SIP operator and put it in first position.

It is alway the previous one (wengo sip operator) used when I make a call .

I found a solution I must remove wengo operator in trunk sequence to force upgrade. is it a normal feaure?

Regards

Richard

This post has been edited 1 time(s), it was last edited by ech on 03.11.2007 at 10:26.