problems with more than one outbound routing

i have 3 different trunks which works as long as I only route outbound calls to one of them.

if i make 2 or more outbound routes with different dial patterns for different trunks, it starts to go crazy. i can only make calls on the first one in the list.

EDIT: if i make more routes i can only use the most recent made of them and if i change the order amongst them with the arrows i cant use any of them.

This post has been edited 1 time(s), it was last edited by qho on 31.12.2006 at 19:35.

Are these trunks from 3 completely different providers, or are all of them from Betamax/Finarea providers?

hi, these are trunks from same provider and server, rix telecom (ipkund3.rixtelecom.se).

What dial string are you sending to the Outbound Route to be sent to these trunks?

Are the outgoing calls via these trunks terminate to the PSTN?

this is one of my dial patterns: 01|0.

and from the terminal i send 01033123456 and that works as long as i have one outbound rule.

I dont understand the second question. What does "terminate to the PSTN" mean?

When I get the hold tone after putting more than one route up, I get "pbxes.org" as trunk in my Call Monitor.

I did some research which yielded this result for Sweden: 010 and 011 are Geographically Independent Numbers / VOIP services.

If all VoIP numbers are 9 digits long and start with a 0, use this string 01|0xxxxxxxx in the Dial Patterns of your Outbound Route and try running the test again.

working fine... thanks for the help