Call log feilds what does "s" under destination mean

Where can I find a description of the call log feilds, specifically destination = s

I have extensions registered, along with VSP inbound and outbound routes. Outgoing calls are perfect but inbound just seems to evaporate.

This post has been edited 1 time(s), it was last edited by vmf on 23.07.2009 at 16:23.

RE: Call log feilds what does "s" under destination mean

Calls don't evaporate. I wish they did, but they don't.

They are just not routed properly to your phones, so verify your Inbound Routes setup.

RE: Call log feilds what does "s" under destination mean

From another PBXES account I get a busy signal. From a mobile it just drops nothing. the call shows on the call log with destination "s" (not sure what that means) but does not display on the status (may be due to the delay in the display).

I've recreated the extension acounts, the trunk accounts and the incoming routes but consistenly have the same probelm.

I was suspecting the codec settings on the 3102 but then I would not be able to dial outbound, which is perfect.

Looking through the system log the line before it says hangup is"Adding non-codec 0x1 (telephone-event) to SDP" this appears to be odd.

Any useful suggestions would be well recieved.

RE: Call log feilds what does "s" under destination mean

Hi,
I see the same destination 's' only when transferring incoming calls from the 3102 to another internal extension.
The transfer happens ok but if I check the call log I see an extra line with the transfer destination 's'.
In the system log I see:
NOTICE[27272] res_features.c: Don't know what to do about control frame: -1
Everything is working perfectly though
Regards
Ron

RE: Call log feilds what does "s" under destination mean

I am also having this problem at least with my Local Phone trunk. It seem to have started this evening at least to my knowledge. Considering it worked before, and I made no changes, I am assuming there is a problem with the system. I do need this fixed otherwise, there is very little point if I have to rely on various devices to handle the VOIP lines. Considering I am disabled, I do use this as my primary phone.

RE: Call log feilds what does "s" under destination mean

At the bottom of the Personal Data section, there is a "Submit & Start" button. Click it once, and verify if the LocalPhone trunk becomes operational again.

RE: Call log feilds what does "s" under destination mean

Zitat:

Originally posted by Diafora At the bottom of the Personal Data section, there is a "Submit & Start" button. Click it once, and verify if the LocalPhone trunk becomes operational again.

Im having the same issue with inbound calls and have tried the method above. This does not fix this issue.

What's going on?