PBXes » English » PBXes PRO » RE: Outbound routing - dial pattern to identify based on lenght
Print Page | Recommend to Friend | Add Thread to Favorites
Post New Thread Post Reply
Author
Post « Previous Thread | Next Thread »
hal


Registration Date: 01.01.1970
Posts:

Outbound routing - dial pattern to identify based on lenght Post Reply with Quote Edit/Delete Post Report Post to a Moderator       IP Information Go to the top of this page

It would be nice if the dial pattern in the outbound routes could identify a number based on lenght as well.

A small bug I found is that if you insert a prefix of 5 number, only calls to numbers 6 or more digits long respect the rule.
Calls with 5 digits are not touched, because the prefix is equal to the whole number and the system expect another figure at the end.

This post has been edited 1 time(s), it was last edited by hal on 23.07.2012 at 19:25.

23.07.2012 19:24 halldis is offline Search for Posts by halldis Add halldis to your Buddy List
baz


Registration Date: 01.01.1970
Posts:

RE: Outbound routing - dial pattern to identify based on lenght Post Reply with Quote Edit/Delete Post Report Post to a Moderator       IP Information Go to the top of this page

can you cliarify? A dialing rul of xxxxx should activate on any 5 digit number. Are you saying 5xxxx (4x) doens't work as expected?

15.08.2012 11:13 bazmercer is offline Search for Posts by bazmercer Add bazmercer to your Buddy List
 
Post New Thread Post Reply
Go to:

Powered by Burning Board Lite 1.0.2 © 2001-2004 WoltLab GmbH
English Translation by Satelk