Trunk extensions - how?

I have few DIDs at the same provider, and my original config was to create separate sub-accounts for each DID, and separate trunks at PBXes.
Apparently provider doesn’t allow using multiple accounts from the same PBX, and suggested me to use one account with extensions, and one trunk at PBXes.

He suggested asterisk config to receive the calls this way, see below. My question is how to achieve this on PBXes?

[from-myprovider]
exten=> 11238000222,1,Dial(SIP/myphone1,...)
exten=> 11238000223,1,Dial(SIP/myphone2,...)

Multiple DIDs on the same trunk

This is possible, via the addition of multiple inbound Routes, if and only if the provider supports multiple DIDs on the same trunk.

Setting this up varies between DID providers, but achieving the proper configuration, is through trial and error most of the time.

RE: Multiple DIDs on the same trunk

Thanks Diafora - I found it

Inbound route trunk name should be set to extension number, that's it.

So if at provider's side DID call comes to SIP/1111/2222 where 1111 is account and 2222 is extension, at PBXes side the inbound route should have just 2222 in Trunk field.

This post has been edited 2 time(s), it was last edited by dor on 15.08.2008 at 22:09.