No outgoing - all circuits are busy |
![Go to the top of this page](images/en/goup.gif) |
Hello, suddenly today I cannot make outgoing calls. I get all circuits are busy, please try your call again later. Everything says registered on the status page and I see no errors in the system log. This is DID provider independent so I assume something is wrong with pbxes somehow. I tried recreating one of my trunk entries and also hopped around on several of the pbxes servers to see if I could figure it out. nothing worked. i have never had an outage this severe
**UPDATE**
I found where the problem is. It was an ENUM outbound route I had created a while back. I don't know why it is now a problem, but in any event I never understood how to use enum. So, I deleted it. Why would this route cause errors?
This post has been edited 1 time(s), it was last edited by mem on 17.07.2008 at 01:39.
|