Omnivoice call through problem

Hi,
I have setup an Omnivoice trunk (GR DID) and registered it with PBXes. Calling in and out worked fine.

I have then tested call thru with a pin and my mobile number Caller ID as the trigger.
When I complete a call with call through, I then cannot make another one. It seems that PBXes returns a busy tone to Omnivoice which directs me towards voicemail.

The call registers to PBXes as:
Destination: s/6972xxxxxxx
IP: host3.de.o­mnivoice.eu
Trunk:omnivoice.eu
Context:ext-did
App:Goto
Duration: 00:00:00

If the call through connects, I get
Context: Callthru
App: WaitExten

Not sure whether this is PBXes or Omnivoice, but as far as I can see, Omnivoice just gets a busy tone from the pbx.

Many thanks
Dimitris.


UPDATE: This goes away when I reboot PBXes but then comes back after a successful call. I am not sure, but I think the PBXes returns a "busy" tone to Omnivoice because the call is not properly hung up.

While on a call, is it possible to instruct PBXes to hang up with a DTMF tone?

This post has been edited 2 time(s), it was last edited by drm on 17.03.2011 at 18:11.

RE: Omnivoice call through problem

Dimitri,

Is this happening using the old OmniV server (sip2.omnivoice.eu) or their new server (sip1.omnivoice.eu)

If you use sip.omnivoice.eu it defaults to their old server sip2.omnivoice.eu

Try with sip1.omnivoice.eu after you transfer some funds from your εξαψήφιο in the old server to your εξαψήφιο in the new server, and let me know if the issue persists.

RE: Omnivoice call through problem

This is with the old server. I will test the new one and get back to you.

Thanks!