Correct configuration of outbound routes

I would like to configure my outbound routes in a way that calls to two specific numbers are routed through one trunk and all others are routed through another one.

My current outbound routes setup looks like this, as far as my understanding goes it should work:

code:

0. MyNumbers   ->  Numbers starting by:   0049XXX 0049YYY   1. outgoing   -> Valid for all numbers

(I put the full numbers in place of 0049XXX/YYY)

but this setup does not work as I wish: all calls are sent through the trunk set as 1. outgoing, even those to the specified numbers 0049XXX/YYY.

Am I doing anything incorrectly? Can somebody guide me in the right direction?