PBXes » English » Feature Requests » RE: Callthru using specific Trunk in Inbound Routing
Print Page | Recommend to Friend | Add Thread to Favorites
Post New Thread Post Reply
Author
Post « Previous Thread | Next Thread »
n9i


Registration Date: 01.01.1970
Posts:

Callthru using specific Trunk in Inbound Routing Post Reply with Quote Edit/Delete Post Report Post to a Moderator       IP Information Go to the top of this page

Hello,

I had a question and if its not possible its a feature request that would help me and many others.

In the inbound routing settings, when you select 'Call Thru', PBXES matches the caller ID and gives me a dial tone. However when I dial a number it uses my Trunk selection using the outbound routing selection settings.

This makes it difficult for me to remember the prefixes when dialing from different numbers.

I was thinking if it is possible to use specific Trunks when dialing using 'Call Thru' without having to dial prefixes but by matching Caller ID of the number I dial from.

So when I dial from a number I entered in Inbound Routing, the Call Thru service dials the number using a specific trunk without having to dial any numbers that select the trunks in Outbound Routing.

Thank you

13.12.2009 06:46 n9ine is offline Search for Posts by n9ine Add n9ine to your Buddy List
i-p
Super Moderator


Registration Date: 14.01.2006
Posts: 4774

RE: Callthru using specific Trunk in Inbound Routing Post Reply with Quote Edit/Delete Post Report Post to a Moderator       IP Information Go to the top of this page

No problem, just enter your caller ID into the extension field of an outbound route.

13.12.2009 11:53 i-p-tel is offline Search for Posts by i-p-tel Add i-p-tel to your Buddy List
 
Post New Thread Post Reply
Go to:

Powered by Burning Board Lite 1.0.2 © 2001-2004 WoltLab GmbH
English Translation by Satelk