RE: Sip Authentication Failure |
|
Hi,
I have a similar problem.
As of today, I can no longer register to my extension #1505 using my ATA (cisco SPA112). On the pbxes status page, my extension is marked as online, although it isn't. I have deleted the extension and recreated it with a new password -- it was immediately seen as online by pbxes although it wasn't. I have created a new extension (#1200) and the ATA fails to register to it. That new extension, however, is correctly seen as being offline on the status page. The ATA does have access to the internet, as it does connect directly to the trunk.
I can connect to my sipdroid extension without any issue.
This has happened after I tried to switch from www3 to www1 after I read on the forum it could possibly help solve a betamax-related issue, which it didn't. I switched back to www3, and since then my ATA can no longer register.
Any help/suggestion welcome.
Kind regards,
Fred
UPDATE:
After maybe 2 hours, the status page shows extension 1505 as offline, which is on par with its current state. The ATA still cannot register though :o(
2ND UPDATE:
I checked the ATA again, after maybe 4 or 5 hours, to find it connected. I did nothing in the interval, leaving the ATA trying to register on and on endlessly. I'm glad it now works, but at the same time am a bit frustrated I don't know what happened and why it couldn't register earlier.
This post has been edited 2 time(s), it was last edited by fsa on 08.04.2013 at 18:07.
|