PBXes (http://www1.pbxes.com/forum/index.php)
- English (http://www1.pbxes.com/forum/board.php?boardid=16)
-- Bugs (http://www1.pbxes.com/forum/board.php?boardid=24)
--- RE: Trunk override with Custom dial pattern - doesnt work? "0|." becomes "0", an (http://www1.pbxes.com/forum/threadid.php?threadid=1353180001)
Trunk override with Custom dial pattern - doesnt work? "0|." becomes "0", and wi
Can anyone help?
i need to setup basic trunk override, i.e.
by dialing 01112223333, i want it to be routed via a specific trunk, without 0 prefix.
i set up additional outgoing rule, move it to the top of the list,
tried setting custom dial rule
0|XXXXXXXXXX
but it always passes the number with unwanted prefix (0)
tried another rule
0|.
but upon save, it becomes 0| for unknown reason, and the number is still dialed as 01112223333, not 1112223333
yes, i selected the radio button for custom dial rule.
yes, i tried putting the pattern into "Numbers starting by:" field
yes, i tried checking "Separate prefix"
nothing works!
am i doing anything wrong?
any help greatly appreciated!!!
RE: Trunk override with Custom dial pattern - doesnt work? "0|." becomes "0", an
Have you tried adding the rule at the trunk level?
RE: Trunk override with Custom dial pattern - doesnt work? "0|." becomes "0", an
Hi
Is that the only rule you have in that particular route? As far as I can tell it scans the list of rules and if any overlap it deletes the second one. "0|." is a valid rule, so I'm not sure why it wouldn't like it.
The thing is, this would send any number beginning with a 0 over that trunk. Is that what you want?
RE: Trunk override with Custom dial pattern - doesnt work? "0|." becomes "0", an
well, i want to use 0 only as a trunk override prefix
so if i dial 02525, i want it to be routed via this particular trunk, and i want 2525 to be dialed, not 02525.
or, in another words, i was thinking to place this trunk on top, and set a rule so that only numbers starting with 0 will be let through it, and dialed without leading zero.
this is a basic wish i think, but i didn't find anything on this in help (
RE: Trunk override with Custom dial pattern - doesnt work? "0|." becomes "0", an
Hi Tico,
I think you should be using an outbound route to select those calls beginning with a 0 and then remove the 0 within the trunk rules.
I'm sure there are old posts about this as well,
Regards
Powered by: Burning Board Lite 1.0.2 © 2001-2004 WoltLab GmbH
English translation by Satelk