PBXes (http://www1.pbxes.com/forum/index.php)
- English (http://www1.pbxes.com/forum/board.php?boardid=16)
-- Feature Requests (http://www1.pbxes.com/forum/board.php?boardid=23)
--- RE: Callthru using specific Trunk in Inbound Routing (http://www1.pbxes.com/forum/threadid.php?threadid=1260683190)

Callthru using specific Trunk in Inbound Routing

Hello,

I had a question and if its not possible its a feature request that would help me and many others.

In the inbound routing settings, when you select 'Call Thru', PBXES matches the caller ID and gives me a dial tone. However when I dial a number it uses my Trunk selection using the outbound routing selection settings.

This makes it difficult for me to remember the prefixes when dialing from different numbers.

I was thinking if it is possible to use specific Trunks when dialing using 'Call Thru' without having to dial prefixes but by matching Caller ID of the number I dial from.

So when I dial from a number I entered in Inbound Routing, the Call Thru service dials the number using a specific trunk without having to dial any numbers that select the trunks in Outbound Routing.

Thank you

RE: Callthru using specific Trunk in Inbound Routing

No problem, just enter your caller ID into the extension field of an outbound route.