PBXes (http://www1.pbxes.com/forum/index.php)
- English (http://www1.pbxes.com/forum/board.php?boardid=16)
-- Bugs (http://www1.pbxes.com/forum/board.php?boardid=24)
--- RE: Trunk sequence problem (http://www1.pbxes.com/forum/threadid.php?threadid=1284809318)

Trunk sequence problem

@IPTel,
Hi, while looking at Betamax IP problems I have noticed that the trunks in my outbound routes are not sequencing properly. This has been mentioned before but was never an issue while all Betamax labels worked OK.
Basically my first outbound route contains 5 trunks, calls fail on the 1st Betamax trunk (error 503) but then jump directly to the 4th trunk missing out the 2 others in between.
Regards

RE: Trunk sequence problem

I am facing a similar problem.

There are 2 trunks in my primary route, and the first one is skipped time and again.

First trunk is a VoipSwitch reseller, second trunk is a Betamax Clone (Rynga).

RE: Trunk sequence problem

There is an indication of three beeps now to show a skipped trunk. So every time a trunk fails, three short beep sounds get played, and after that the number gets dialed on the next trunk in sequence (if any).